2003 Lexus GS 300 PARK/ NEUTRAL POSITION SWITCH MALFUNCTION
download Park/neutral position switch detects the shift lever position and sends signals to the ECM. The ECM receives signals (P, R, N, D, 4, 3, 2 and L) from the park/neutral position switch. When the...
View Article1999 Daewoo Nubira SX TIMING BELT REMOVAL & INSTALLATION
download Removal 1. Disconnect negative battery cable. Disconnect intake air temperature sensor connector from intake air duct. Disconnect the air intake tube from the throttle body. Disconnect the...
View Article1999 Pontiac Grand AM Revised Timing Chain, Sprocket, and Tensioner Replacement
download Note: GM does not provide timing chain timing marks, or information to perform timing chain service without the special tools shown in this procedure. Tools Required: – - J 36800 Camshaft...
View ArticleRover 820 16 Valve (M16 Engine) Timing Belt Failure
download The above application is prone to the timing belt teeth lifting off the belt in service due to operating the belt with insufficient tension. The following instructions have been produced to...
View Article1993 Mercury Villager LS MANUFACTURER’S SUGGESTED SCHEDULED MAINTENANCE
download For 1993, the manufacturer recommends the belt be replaced every 60,000 miles. For 1994-98, the manufacturer recommends the belt be replaced every 105,000 miles. Installation 1. Ensure...
View Article1994 Ford Aerostar/Ranger/Explorer Camshaft Timing ADJUSTMENTS
download Checking Timing An access plug is provided in the cam drive belt cover so that camshaft timing can be checked without removal of the cover or any other parts. 1. Remove the access plug from...
View Article1996 Mitsubishi Eclipse GS-T TIMING BELT & BALANCE SHAFT BELT Removal
download 1. Disconnect negative battery cable. Remove engine undercover. Place wooden block between jack and oil pan, and raise engine slightly. Remove engine mount assembly near timing belt cover. 2....
View Article2003 TOYOTA TACOMA TIMING BELT INSTALLATION REMOVAL
download NOTICE: Always turn the crankshaft clockwise. (c) Check that the timing marks of the camshaft timing pul- leys and No.3 timing belt cover are aligned. If not, turn the crankshaft pulley 1...
View Article1998 Ford Windstar Camshaft Position (CMP) Sensor REMOVAL AND INSTALLATION
download CAUTION: Prior to removal of the camshaft position sensor (CMP sensor) (12126) , set cylinder No.1 to zero degrees top dead center (TDC) of compression stroke. Then note the position of the...
View Article1995 Ford Mustang Camshaft Position (CMP) Sensor Removal Installation
download 1. Disconnect battery ground cable (14301) . 2. Disconnect fuel charging wiring (9D930) from distributor stator (12A112) (camshaft position sensor). 3. Remove stator camshaft position sensor...
View Article
More Pages to Explore .....